Installation Instructions

Try installation of the adapters without any rubber grip strips first, if its loose then add the strips
Tighten until the spring washer is almost fully compressed, do not over tighten
Use the rubber washers around the cradles to stop slipping and movement
Loosely assemble the mount(finger tight), insert the camera and align, remove the camera then fully tighten
ALWAYS use a safety strap through the camera body (top right corner) in case of mount failure
Do not mount the camera where it will be subjected to impact from foreign objects

Install the adapters if required (with rubber strips if needed)
Screw the threaded rod into the camera
Place the mount on the bars or over the adapter, the flat side should be at the top
Insert the camera into the mount and align the camera as required
Fully tighten

Test install the camera (get a buddy to hold it in position) on the helmet to get the best location
Mark the location of the camera mount on the helmet
Install the supplied dual lock on the helmet/surface
Get the hot water running - Be careful around hot water! Do not burn yourself
Heat the mount up under the water, you will see it start to soften
Place on the helmet and gently push into place
Continue to heat and mount each part of the mount so it is a perfect fit
Screw the camera on and press onto helmet/surface

Install the adapters if required (with rubber strips if needed)
Place the mount on the bars or over the adapter, the flat side should be at the top
Hold the cradle in place (with rubber washers) and insert the bolt through the top of the clamp and cradle
Hold the seat in place and then push the bolt through the assmebly, you may have to screw it in
Put the washers and nut on, fasten lightly
Insert the camera into the mount and align the camera as required
Remove the camera and fully tighten

Install the adapters if required (with rubber strips if needed)
Place the clamp on the seatpost or over the adapter
Hold the cradle in place (with rubber washers) and insert the bolt through both the clamp and the cradle
Put the washers and nut on, fasten lightly
Insert the camera into the mount and align the camera as required
Remove the camera and fully tighten

Install the adapters if required (with rubber strips if needed)
Place the clamp on the seatpost or over the adapter
Hold the cradle in place (with rubber washers) and insert the bolt through both the clamp and the cradle
Put the washers and nut on, fasten lightly
Insert the light into the mount and align the light as required
Remove the light and fully tighten

Install the adapters if required (with rubber strips if needed)
Place the clamp on the bars or over the adapter
Place the cradle & bolt through the clamp, installing one nut between the clamp ends
Put the second nut on the bolt to secure the clamp
Place the torch (with adapters if required) in the cradle and tighten (do not over tighten)
Align the torch so that it is pointing in the correct direction
Tighten the upper bolt firmly so the torch will not rotate (or just slightly if required)
Tighten the lower bolt finger tight, do NOT overtighten or the mount can snap
ALWAYS use a safety strap through the torch body (tail cap) in case of mount failure